Mazda 3 2015, 150k miles. Knocking noise going over bumps. Can’t tell if it’s sway bar link, outer tie rod end, ball joint, all the above, or none of the above.

Aluminium can look like this right? Right?? I have no money left, ts has costed me about 2k already

I heard some popping noise yesterday while driving and when I returned home I checked under the hood I found my strut in 2 pieces. My mechanic is 8 min drive a

Not the best video, but lately im hearing a buzzing sound when I drive my car coming from the right side. I currently drive a 2015 subaru legacy 2.5i premuim. I

Honda Civic 2015 LX with 108k miles on it. Never had any suspension components changed. Makes the same noise when coming to or accelerating from a stop. Lis

Only clunks after first time hitting gas in either forward in reverse. Only happens once each way. I’m assuming it’s motor mounts but I really want it to be som

These came with my head gasket set and I can't seem to figure out what they are for

I’m working on an old sportster that uses 1/2 ID oil lines in some sections and 3/8 in others. 3/8 was easy to find but this is the only 1/2 ID hose I can find

Just recently replaced my pads and rotors on front and rear. Noticed holes on caliper dust boot in front while doing rotors/pads and piston was for sure seized

2012 ford fusion 2.5L 103,000 miles Coolant seems over filled is this a red flag? Car seems to run good and didn’t over heat for the 30 mins we drove/had it ru

I installed some aftermarket fog lights and took it to the mechanic to help me out with the wiring. I’m scared that these wires may catch on fire. Are these saf

I have a few codes on my 13 Chevy Malibu. P0132,P0420,P2097. Car is running rough idle & stalls.. I replaced both my upstream & downstream 02 sensors al

Front control arms were replaced a couple of weeks ago. Now that I pay attention the car makes a clunking sound (coming from the front wheels) when driving on u

I woke up one day and my car wouldn’t start. (As you can see in the video) I remove the air filter box and unclip some tubes and a plug that goes to the box bec

1998 E200 Mercedes Benz Automatic 136hp This car has been sitting in a barn since December of 2011, beach of high maintenance fees ,my dad wants to scrap it but

I bought a 2014 Kia soul towards the end of 2023 and she did great for the first year. Then the drivers side door stopped working, then the AC went out, then th

I upgraded my front calipers to some Genesis Brembos but seem a bit close. They spin freely and I have driven a little bit with them. I mainly drive on the road

2004 Camry LE. I aligned my car using win toe and without (I’m a tech) and the steering wheel was off center to the right and would drift/pull that way too. I a