Aluminium can look like this right? Right?? I have no money left, ts has costed me about 2k already

Mazda 3 2015, 150k miles. Knocking noise going over bumps. Can’t tell if it’s sway bar link, outer tie rod end, ball joint, all the above, or none of the above.

2012 ford fusion 2.5L 103,000 miles Coolant seems over filled is this a red flag? Car seems to run good and didn’t over heat for the 30 mins we drove/had it ru

I heard some popping noise yesterday while driving and when I returned home I checked under the hood I found my strut in 2 pieces. My mechanic is 8 min drive a

I needed to change the oil filter holder because of a stripped screw on the bottom of my old one - and the new filter cover i bought seems just very minimally d

Can someone tell me if this is correct does the three at the end look changed or defect or is this normal for this cam?? comments would be great

New to car maintenance, been learning the basics from Youtube. Don’t have a ton of tools besides a set of wrenches and floor jack and stands. I couldn’t get the

In a span of year the product in a photo was recommended by one mechanic and disapproved by other mechanic. The reason first mechanic recommended it is becaus

I have a 2006 Hyundai Elantra. To give you a little background to the car: It has about 152,000 miles on it. The car is regularly taken care of. Oil chang

For context 2015 Kia Soul Base, with 1.6 4 cylinder engine.

Just recently replaced my pads and rotors on front and rear. Noticed holes on caliper dust boot in front while doing rotors/pads and piston was for sure seized

my dumb ass reversed into the edge of a wall when i wasn’t paying attention and i just noticed a piece of this rubber part broke off like the rubber bit broke w

Hi! Im trying to change the outer cv joint boot, but have no luck with getting the joint out. I’ve bought this tool that I’ve seen many recommend for this but I

I have a 2005 dodge grand caravan 3.3l v6 gas no flex. I was driving the other day and it completely shut off turned out had a faulty fuel pump installed. Just

Valve got stuck so in all my wisdom I thought "A little hammering with a valve should do it" surprise, 1 bent valve, stuck valve and chipped engine head later.

Started to notice this loud noise whenever i go over any bump. Made my girl bounce while i tried to pin point it and definitely heard it from the passenger side

I had my car in for a rear wheel bearing replacement start of 2022 a few days ago I had to change it again but this bearing hub looked very very old I suspect t