Mazda 3 2015, 150k miles. Knocking noise going over bumps. Can’t tell if it’s sway bar link, outer tie rod end, ball joint, all the above, or none of the above.

Aluminium can look like this right? Right?? I have no money left, ts has costed me about 2k already

I heard some popping noise yesterday while driving and when I returned home I checked under the hood I found my strut in 2 pieces. My mechanic is 8 min drive a

These came with my head gasket set and I can't seem to figure out what they are for

2012 Subaru Legacy 2.5iPremium 2.5L H4 SOHC 16v If its not normal do I need to replace the whole power steering pump or just the pulley? How would I tell.

Our dash cam is plugged into the lighter socket next to the gear shifter, and it will stay on for the entire day when the car is off. I'm worried |tll drain the

Grandma just got back home and claims this started when she pulled in the driveway. Engine sounds really rough so we had her turn it off and now it won’t run at

It’s a 10 gen civic ex

I went to get an oil change this morning and was informed that my transmission oil pan is leaking on my 2016 honda civic. I've attached a picture. I'm wondering

So my 2011 bmw e93 335i’s rpm revs up like 1500rpm 1 second after starting the engine. And it’s also having an error code 28A0 throttle angle-absolute pressure

Hi everyone, it is my first time changing front wheel bearings on my car. I have manged to remove the hub, remove the snap ring (after much struggling), but whe

We had our car serviced at the shop recently. I went to drive it and there was a loud pop/crackle, I wasn’t sure if it was my car. Later the EPC light came on a

I got quoted almost 2k just to fix my catalytic converter and 2 oxygen sensors but i was searching and came across this one. do you think this will be fine ? ki